Spray foam insulation prices at a glance
Spray foam insulation commonly costs $1.50 to $3.50 per square foot for open-cell and $3.00 to $5.00 per square foot for closed-cell in published 2026 national planning data. Those are not Binghamton contractor quotes, and they do not tell you the final price by themselves. The treated surface area, specified depth, access, masking, existing-insulation removal, substrate repairs, and whether the building is occupied can move a project substantially.
Published national project ranges put attic work around $3,000 to $8,000, exterior-wall work around $4,000 to $10,000, crawl-space work around $2,000 to $4,000, and rim-joist work around $2,000 to $2,500. Use these figures to test whether a quote is plausible, not to predict what your building must cost. They were verified on 17 August 2026 from HomeGuide's spray foam cost data.
The useful number is the price attached to a written scope. That scope should name the product, application area, thickness, preparation, containment, ventilation, re-entry protocol, cleanup, protection, and exclusions. A quote that says only "spray foam" and a total is impossible to compare safely.
Cost ranges by application
The table below is a planning tool built from national 2026 data. A local proposal should replace these ranges with measured quantities and a product-specific scope.
| Application | Published planning range | What must be defined |
|---|---|---|
| Attic roofline or ceiling plane | $3,000 to $8,000 | Boundary, treated area, depth, roof condition, ventilation, removal |
| Existing exterior walls (injection foam) | $4,000 to $10,000 | Cavity count, access method, siding or patching, wiring, fill verification |
| Crawl space | $2,000 to $4,000 | Wall or floor boundary, moisture work, access, ground vapor control |
| Rim joists | $2,000 to $2,500 | Bay count, obstructions, old insulation removal, sill condition |
| 2,000 square feet of treated surface | $3,000 to $10,000 | Product, thickness, staging, masking, number of setups |
Floor area is often the wrong measurement. A 1,200-square-foot house does not automatically have 1,200 square feet to spray. Roof slope increases roof-deck area, wall height changes wall area, and a pole barn quote may include both its roof and walls.
Open-cell and closed-cell prices are not interchangeable
Closed-cell spray foam normally costs more per treated square foot because it is denser and delivers more R-value per inch. Published typical ranges are R-5.0 to R-7.0 per inch for closed-cell and R-3.5 to R-3.7 per inch for open-cell. The actual value for your project comes from the product's technical data sheet, not a generic range.
| Decision factor | Open-cell spray foam | Closed-cell spray foam |
|---|---|---|
| Published installed range | $1.50 to $3.50 per sq. ft. | $3.00 to $5.00 per sq. ft. |
| Typical R-value per inch | R-3.5 to R-3.7 | R-5.0 to R-7.0 |
| Vapor behavior | More vapor permeable | Less vapor permeable at sufficient thickness |
| Space needed for a target R-value | More | Less |
| Common quote mistake | Selected only because it is cheaper | Selected everywhere because it is "stronger" |
The lower material rate is not automatically the lower project rate. If an assembly needs more depth, a separate vapor-control layer, or additional detailing, compare the complete assembly rather than one line item. Read the full closed-cell versus open-cell guide before choosing a product.